Powercore TEC-10

Murphy's PowerCore^® TEC-10 panel provides full control with easy setup and installation.

A superior turnkey electronic controller, the PowerCore^® TEC-10 panel provides full control of your engine including auto start/stop, auto throttling and display of engine parameters along with critical faults from the engine/application. The TEC-10 supports SAE J1939 CAN protocols for electronically governed engines as well as analog sensors on mechanical engines for fault and safety warnings/shutdowns. The TEC-10 can also be remotely automated and monitored using the Murphy CONNECT telematics unit.

Interface

Display :
- Monochrome HR-TFT
- 2.7 in./ 68 mm, WQVGA (400 x 240 pixels)
- Languages: English, Spanish, German, French, Italian
(3) LEDs : green (mode), yellow (warning) and red (shutdown)
Operator controls :
- (11) Raised silicone keypads, tactile feedback
- (1) Rotary switch, power on/off
- (1) Push-switch (red), engine stop

Power Supply:

Operating Voltage : 8-32 VDC, reverse battery polarity and load dump protected
Cranking Power Holdup : 0 VDC up to 50 mS(also good for brownout/blackout instances)
Current consumption : Power on in stopped state; 117 mA at 12 VDC. Power on in standby mode; 52 mA at 12 VDC.

Inputs (9):

(5) Digital, configurable (active on High, Low, Open)
(3) Analog, configurable (4-20 mA, 0-5V, resistive or digital ground)
(1) Frequency, supporting: Magnetic pickup (30 Hz - 10 kHz, 2.0 VAC-120 VAC) and Engine Alternator (30 Hz - 10 kHz, 4.5 VRMS - 90 VRMS)

Outputs (8):